ATTENTION! IMPORTANT FITMENT REQUIREMENTS:
- The Factory Power Inverter Option is REQUIRED for compatibility.
- A Factory Inverter Switch Harness Connector is also REQUIRED for compatibility. Prior to placing your order, please confirm that your vehicle is equipped with the inverter switch harness connector, as it is not present on all Gladiators.
- If present, the connector will be located behind the dash panel, directly where the inverter switch mounts. For a reference image of the required connector, please click here.
115 Volt Pickup Bed Outlet Kit (For 2024-2025 Gladiators):
- This genuine Jeep kit from MoparOnlineParts provides all components required for installation of the production bed outlet (Passenger Side / Right Rear Location)
- 115 Volt / 400 Watt Outlet is installed within the bed at the right (passenger side) rear location next to the tailgate.
- Same as the production option.
- Replaces Part Number: 68312754AB
- Please read all fitment and application details prior to placing your order, as this kit does not fit all Gladiators.
- For installation instructions, please click here.
Gladiator Bed Plug Kit Contents (All Original Equipment OE Mopar Parts):
- Inverter Switch – 68370049AA
- Jumper Wiring – 68616398AB
- Inverter Power Outlet – 68312754AC
- Tapping Pan Head Screw And Washers – 6505628AA (x4)
- Plastic Nuts – 6509748AA (x4)
PLEASE NOTE:
- Programming is required via a 3rd party programmer such as Z Automotive Tazer or J-scan. Not Included.
- This kit is NOT applicable to (2020-2023) vehicles due to a change in the required wire harness. Please use Part Number BEDOUTLETKITJT20 instead.
- Wire harness shown in product image is for reference only and shows a generic Jeep wire harness. Products are not shown to scale.
